How to maintain and maintain electric rolling shutter doors

After the electric rolling shutter door is installed, in order to keep it running smoothly for a long time and reduce the failure rate. Maintenance and maintenance in the later use process is the key. So how should the maintenance and maintenance of the electric rolling shutter door be carried out? Let me tell you today.

1. When using the electric rolling shutter door, try to maintain the stability of the controller and voltage. It is forbidden to install and use it in a very humid environment. In addition, if there is a wire winding on the door body, do not open the remote control at will. If the wire is knotted, etc., it should be dealt with in time. During use, pay attention to whether the channel is blocked and the door body is hindered from descending. If there is an abnormal response, stop the motor operation immediately.

2. Regularly check the switch of the up and down stroke of the electric rolling shutter door. Add lubricating oil to the stroke controller to keep it running normally and well. In addition, the operator manually controls the rolling shutter door, checks the operation of the instrument, and proofs the switch position of the up and down stroke, so that the electric rolling shutter door is in the appropriate position when it is opened or closed, and prevents the electric rolling shutter door from rushing to the top or bottom or reversing during the inspection process. In case of emergency, stop operation immediately and cut off the power supply.

3. The operator should regularly check the manual switch and manual lifting device of the electric rolling shutter door to prevent the electric rolling shutter door from failing or causing unnecessary safety accidents in an emergency.

4. Keep the track running smoothly, clean the electric rolling shutter door track in time, and keep the interior clean. The rolling shutter door motor and transmission chain should add lubricant frequently, check the control box equipment and switch control box, fasten wiring ports, fastening screws, etc., and clean the dust and dirt on the surface of the control box and buttons to prevent the buttons from getting stuck without rebounding.

Recommended news

■

What should I do if the sound insulation of the windows is not good? How to deal with it?

2023/02/18